Pioneer DVR-560HX-K Operating Instructions Manual page 162

Additional information
19
Message
• The Hard Disk Drive info is incorrect.
Use the Disc Setup menu to reinitialize.
• This signal's TV system is different
from the recorder's setting.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear
message.
• Playback has stopped because the TV
system is different than the recording.
• You are not allowed to watch this
Conditional Access Programme.
• There is no DV input or the input
signal is unrecordable.
• No DV camcorder connected.
• You cannot connect more than one
DV camcorder at a time.
• Cannot operate the DV camcorder.
• Could not operate the DV camcorder.
• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder.
• The printer is not ready or is not
connected. Please check the printer.
162
En
Explanation/Action
As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 130) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
The TV system (PAL, NTSC, etc.) of the current
channel is different from the TV system settings of
this recorder.
The timer recording failed because the TV system
of the channel set for recording was different from
the setting of the recorder.
During recording or timer recording standby, the
TV System (PAL, NTSC, etc.) of the playback video
changed, causing playback to stop automatically.
A CA module or smart card (obtained from your
service provider) is required to watch the selected
programme. Insert the supplied module or card
into the Common Interface card slot on the front
panel of the recorder (page 27).
No signal was detected at the DV IN jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
The camcorder is not connected properly, or the
camcorder is switched off.
This recorder's DV jack supports connection to
just one camcorder.
This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
This recorder was not able to operate the DV
camcorder.
The camcorder is in camera mode. Switch it to
playback mode.
This message is displayed when communication
could not be established with the printer. See the
Troubleshooting section if you do not know the cause.