Pioneer DVR-560HX-K Operating Instructions Manual page 137

The Initial Setup menu
Setting Options
Manual CH Next Screen
Setting
Channel Next Screen
Swapping
Video In/Out
Input Colour Next Screen
System
• Input Colour System cannot be set when the recorder is in D.TV mode.
• See also About the input colour system on page 148 for more information on this setting.
Component Interlace •
Video Out
Progressive
• For Component Video Out to be effective, the AV1 Out setting (see page 138) must be set to something other than
RGB.
• If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any
picture at all. In this case, press  OPEN/CLOSE while holding down the  (Stop) button on the front panel to
switch to Interlace (this also switches Screen Resolution on page 144 to the default setting).
•
When the HDMI signal is output, no video is output from the COMPONENT VIDEO OUT
Explanation
Proceed to the next screen if you need to adjust any of the
settings made by auto tuning. Select your country, then
proceed to the manual channel setting screen:
• Change channel presets using the CHANNEL +/– buttons.
• To skip the displayed channel (because there is no station
assigned to that channel), change the Skip setting to On.
• Set the CH SYSTEM setting to match the channel system
of your country or region.
• Set the CHANNEL setting to the channel you want to
assign to the current channel preset.
• To manually fine tune the channel, change the AFT setting
to Off then adjust the Level setting.
• Set the Sound System setting to match the sound system
of your region.
• The Name field allows you to input a name of up to five
characters for the current channel preset.
• If the currently selected channel is scrambled requiring a
decoder connected to the AV2 (INPUT 1/DECODER), set the
Decoder setting to On.
Proceed to the next screen to swap channel assignments of
different presets so that you can group together presets that
naturally go together. Select two presets to swap then press
ENTER.
Proceed to the next screen to set the input colour system for
the external input and the built-in TV tuner. Use the
CHANNEL +/– or INPUT SELECT buttons to change the
preset or external input. On the default Auto setting the
recorder can generally correctly detect whether the input
signal is PAL, SECAM, 3.58 NTSC or PAL-60, but in some
cases you may have to set it manually if the picture is
displayed incorrectly.
Select if your monitor/TV is not compatible with progressive-
scan video.
Select if your monitor/TV is progressive-scan compatible.
Check the operating instructions that came with your
monitor/TV if you're not sure.
18
.
137
En