Installation & Connection; Power Supply - Samsung SCB-6001 User Manual

installation & connection
external Day/night Switching input
Day/Night mode of the camera can be switched by signal from an external device.
To use this function, <DAY/NIGHT> setting of the camera should be set to the <EXTERN>.
`
J
(Page 27)
motion Detection Signal out
Upon a motion detection, the port outputs signal for an external device for display or operation.
When a motion is detected, the port outputs 3.3V signal.
To use this function, <ALARM OUT> setting of the camera should be set to <ON>. (Page 31)
`
J

power Supply

Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
Be careful not to reverse the polarity when you connect the power cable.
`
J
Be sure to turn the power off the device to be connected.
`
DVR
System Controller
for ac/Dc power Supply
You can use either one of AC 24V/1A~2A and DC 12V/2A~4A adaptor.
16_ installation & connection
or
PC
HD-SDI
VIDEO
POWER
1 : GND
2 : EXT_D/N
3 : MD_OUT
4 : RS_485+
5 : RS_485-
Power