Connecting With Other Device; Video Cable - Samsung SCB-6001 User Manual

connectinG witH otHer Device

Day/Night mode
controller
connecting to the monitor
Connect the video out port of the camera to the video input port of the monitor.
To check the display screen after installing the camera for the first time, you can use the Video
`
J
port to check the video screen.
You can set the video output type to either NTSC or PAL. (page 29).
`
The Video source (4:3) will be displayed with either side truncated in comparison with the
`
HD-SDI video.
The video source from the HD-SDI port can be displayed on the dedicated monitor. To display the
`
source on a commercial monitor, you need a converter to convert the video signal as appropriate.

video cable

The cable connecting the camera's video output and a monitor is a BNC coaxial cable as
shown below.
If the distance between the camera and the monitor exceeds the recommended maximum,
please us an auxiliary video amp.
HD-SDI
HD-SDI
VIDEO
1 : GND
2 : EXT_D/N
3 : MD_OUT
4 : RS_485+
5 : RS_485-
Motion detection output device
Maximum video transfer
HD-SDI Monitor
POWER
Test monitor for
installation
Recommended cable
distance
100~140m
200m
specification
5C2V(75ohm)
L-6CHD(75ohm)
(SDI-specific Cable)
English _15