Displaying the Available Management Ethernet Interfaces
Command or Action
Step 8
end
Example:
RP/0//CPU0:router(config)# end
Step 9
show interfaces MgmtEthrack/slot/CPU0/port
Example:
RP/0//CPU0:router# show interfaces
MgmtEth0/RP0/CPU0/0
Examples
The following example shows how the Management Ethernet interface on the in slot is configured with
an IP address:
RP/0//CPU0:router# configure
RP/0//CPU0:router(config)# interface MgmtEth0//CPU0/0
RP/0//CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0
RP/0//CPU0:router(config-if)# no shutdown
RP/0//CPU0:router(config-if)# commit
RP/0//CPU0:router(config-if)# end
RP/0//CPU0:router#
RP/0//CPU0:router# show interfaces MgmtEth 0//CPU0/0
MgmtEth0//CPU0/0 is up, line protocol is up
Interface state transitions: 1
Hardware is Management Ethernet, address is 0011.93ef.e8e6 (bia 0011.93ef.e8e6)
Description: Connected to Lab LAN
Internet address is 172.29.52.70/24
MTU 1514 bytes, BW 100000 Kbit
Encapsulation ARPA,
Half-duplex, 100Mb/s, 1000BASE-T, link type is autonegotiation
output flow control is off, input flow control is off
loopback not set,
ARP type ARPA, ARP timeout 04:00:00
Last input 00:00:00, output 00:00:00
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
68
reliability 255/255, txload 0/255, rxload 0/255
31371 packets input, 1922996 bytes, 153 total input drops
0 drops for unrecognized upper-level protocol
Received 19457 broadcast packets, 0 multicast packets
12 runts, 0 giants, 0 throttles, 0 parity
61 input errors, 27 CRC, 12 frame, 0 overrun, 0 ignored, 0 abort
12869 packets output, 878236 bytes, 0 total output drops
Chapter
Purpose
Saves configuration changes.
•
When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
•
Entering no exits the configuration session and
returns the router to EXEC mode without committing
the configuration changes.
Entering cancel leaves the router in the current
•
configuration session without exiting or committing
the configuration changes.
Displays interface details to verify the settings.
Configuring General Router Features
OL-28417-02