Firmware Upgrade - Cisco ASR 9000 Getting Started Manual

Chapter Bringing Up Cisco IOS XR Software on the Router
Active node reload "Cause: Turboboot completed successfully"
Standby node reload "Cause: self-reset to use new boot image"
show environment Command: Example
To display environmental monitor parameters for the system, use the show environment command in
EXEC or administration EXEC mode. The show environment [options] command syntax is used.
Enter the show environment ? command to display the command options.
RP/0/RSP0/CPU0:router# show environment temperatures
The following example shows temperature information for a Cisco ASR 9000 Series Router.
Mon May 31 02:44:19.989 DST
R/S/I
0/1/*
0/RSP0/*
0/4/*
0/6/*
The following example shows LED status of the nodes in a Cisco ASR 9000 Series Router.
RP/0/RSP0/CPU0:router# show environment leds
Mon May 31 02:46:17.343 DST
R/S/I
0/RSP0/*
For more information, see Cisco ASR 9000 Series RouterInterface and Hardware Component Command
Reference document.

Firmware Upgrade

The field-programmable devices (FPDs) are hardware devices implemented on router cards that support
separate software upgrades. A field-programmable gate array (FPGA) is a type of programmable
memory device that exists on most hardware components of the router. The term FPD is introduced to
OL-28417-02
Modules Inlet
Temperature
(deg C)
host 36.1
host 30.8
host 34.4
host 37.3
Modules LED
host Critical-Alarm
host Major-Alarm
host Minor-Alarm
host ACO
host Fail
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
Hotspot
Temperature
(deg C)
45.1
41.5
44.5
47.9
Status
Off
Off
Off
Off
Off
Firmware Upgrade
35