Cisco ASR 9000 Getting Started Manual page 22

Cisco ASR 9000 Series Router Overview
Mapping of Address and Port-Translation Mode (MAP-T)—This feature enables IPv4-only clients
•
to communicate with IPv6-only resources using address and packet translation. MAP-T is also
referred to as Dual IVI (dIVI) or Stateless NAT46. For more information on MAP-T, see the Cisco
ASR 9000 Series Aggregation Services Router CGv6 Configuration Guide.
Integrated service module (ISM) High availability (HA)—This feature provides continuous access
•
to applications, data, and content anywhere, anytime by addressing potential causes of downtime
with functionality, design, and best practices. For more information on ISM HA, see the Cisco ASR
9000 Series Aggregation Services Router CGv6 Configuration Guide.
IPv6 ACL on L2 Interface—This features enables to specify a particular IPv6 access list on L2
•
interfaces for processing and discarding the packets. For more information on IPv6 ACL on L2
Interface, see the Cisco ASR 9000 Series Aggregation Services Router IP Addresses and Services
Configuration Guide.
IPv6 Service Level Agreements (SLA) Internet Control Message Protocol (ICMP) Echo Op EOT for
•
HSRIPv6and IP Static— This feature is used to monitor end-to-end response time between a Cisco
router and devices using IP. For more information on IPv6 SLA ICMP Echo Op EOT, see theCisco
ASR 9000 Series Aggregation Services Router IP Addresses and Services Configuration Guide.
ABFv4 over IRB/BVI—This features enables to configure ACL-based forwarding (ABFv4) over
•
Integrated Routing and Bridging (IRB)/Bridge-Group Virtual Interface (BVI) interface. For more
information on ABFv4 over IRB/BVI, see the Cisco ASR 9000 Series Aggregation Services Router
IP Addresses and Services Configuration Guide.
TI MoRR Global Table IP PIM—This multicast feature enables to perform the fast convergence
•
(Fast ReRoute) for specified routes/flows when failure is detected on one of the paths between the
router and the source. For more information on TI MoRR Global Table IP PIM, see the Cisco ASR
9000 Series Aggregation Services Routers Multicast Configuration Guide.
Multiple I-SID Registration Protocol (MIRP) Lite—This feature enables detection of a topology
•
change at a site. For more information on configuring MIRP, see the Implementing IEEE 802.1ah
Provider Backbone Bridge module in the Cisco ASR 9000 Series Aggregation Services Router
L2VPN and Ethernet Services Configuration Guide.
Pseudowire Headend (PWHE)—This feature allows termination of access pseudowires (PWs) into
•
a Layer 3 (VRF or global) domain or into a Layer 2 domain. For more information on PWHE, see
the Cisco ASR 9000 Series Aggregation Services Router L2VPN and Ethernet Services
Configuration Guide.
Typhoon L2 Scale Enhancment—This feature enable providing scale enhancements on ASR 9000
•
Enhanced Ethernet line card. For more information on L2 Scale Enhancement, see the Cisco ASR
9000 Series Aggregation Services Router L2VPN and Ethernet Services Configuration Guide.
• Satellitenv–QoS enhancements—This feature enables supporting upto 14 unique shape rates for 1G
port shapers and reconfigure any policy-maps based on underlying satellite ports speed. For more
information on Satellitenv-QoS enhancements, see the Cisco ASR 9000 Series Aggregation Services
Router Modular Quality of Service Configuration Guide.
Asynchronous Syslog Communication—This feature enables proper ordering of messages testing
•
on each node (LC, RP), non dropping of messages generated from multiple clients on each node
(LC, RP) and checking performance, scalability and latency by sending log messages at incremental
rates. For more information on Asynchronus Syslog Communication, see theCisco ASR 9000 Series
Aggregation Services Router System Management Configuration Guide.
• Syslog Enhancement—This feature enables adding keywords year in both service timestamp log
datetime and service timestamp debug datetime and severity in the existing logging cli. For more
information on Syslog Enhancement, see the Cisco ASR 9000 Series Aggregation Services Router
System Monitoring Command Reference.
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
110
Introduction to the Cisco ASR 9000 Series Aggregation Services Router
OL-28417-02