Displaying The Active Configuration Sessions - Cisco ASR 9000 Getting Started Manual

Managing Configuration Sessions
Figure 12
EXEC mode
Administration
Global configuration mode is used to configure features, such as routing protocols and interfaces.
Administration configuration mode is used to assign hardware components to .
The following sections describe the management options for configuration sessions:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Displaying the Active Configuration Sessions

Before you start a configuration session, you should check if there are other configuration sessions in
progress. More than one user can open a target configuration session at a time, allowing multiple users
to work on separate target configurations.
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
52
Two-Stage Configuration Process
Global
configuration
mode
Administration
configuration
mode
mode
Displaying the Active Configuration Sessions, page 69
Starting a Configuration Session, page 70
Starting an Exclusive Configuration Session, page 71
Displaying Configuration Details with show Commands, page 71
Saving the Target Configuration to a File, page 79
Loading the Target Configuration from a File, page 80
Loading an Alternative Configuration at System Startup, page 80
Clearing All Changes to a Target Configuration, page 80
Committing Changes to the Running Configuration, page 81
Reloading a Failed Configuration, page 83
Exiting a Configuration Submode, page 83
Returning Directly to Configuration Mode from a Submode, page 84
Ending a Configuration Session, page 84
Aborting a Configuration Session, page 85
Configuring the SDRRSP Hostname, page 85
Configuring the Management Ethernet Interface, page 85
Specifying the Management Ethernet Interface Name in CLI Commands, page 86
Displaying the Available Management Ethernet Interfaces, page 87
Configuring the Management Ethernet Interface, page 89
Chapter Configuring General Router Features
Stage 1:
Enter configuration
changes or load a
saved configuration.
Save configuration
changes to a file.
Stage 2:
"Commit" changes
to the running
configuration.
OL-28417-02