Preparing The Camera - Cisco PTZ Installation Manual

Installing the PTZ IP Camera
o: white/orange stripe
O: orange solid
g: white/green stripe
B: blue solid
b: white/blue stripe
G: green solid
br: white/brown stripe
BR: brown solid
Feed the Ethernet cable and I/O wires through the mounting bracket, the openings on the dome cap, and
Step 5
to the interface section. Attach the rubber seal plug to dome cap for water proofing.
Step 6 Secure the included ground wire to the dome cap, pass it through the mount bracket, and connect the
other end to a grounded conduit later.

Preparing the Camera

Prior to mounting the camera to the wall or ceiling, attach the silica gel packets to the camera using these
steps.
Step 1 Remove the black dome cover of the camera.
Step 2 Turn the camera upside down.
Step 3 Attach the silica gel packets to the inside wall of the camera using the adhesive strips.
Cisco Video Surveillance PTZ IP Camera Installation Guide
2-6
o
1
O
2
g
3
4
B
b 5
G 6
br 7
BR 8
Chapter 2 Installing the Camera
OL-28954-01