Installing The Ptz Ip Camera - Cisco PTZ Installation Manual

Chapter 2 Installing the Camera
•
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
The power supply must be placed indoors. Statement 331
Warning
Note
Warning This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source
or an IEC60950 compliant limited power source. Statement 353
Inline power circuits provide current through the communication cable. Use the Cisco provided cable or
Caution
a minimum 24AWG communication cable.
The power adapter that you use with the IP camera must provide power that is within +/–10% of the
Note
required power.
The equipment is to be connected to a Listed class 2, limited power source.
Note

Installing the PTZ IP Camera

Use the procedures in this section to install the PTZ IP camera.
OL-28954-01
Do not drop the PTZ IP camera.
If you use the IP camera outdoors, place the camera and the power supply in a suitable NEMA
enclosure.
Cisco Video Surveillance PTZ IP Camera Installation Guide
Installing the PTZ IP Camera
2-3