Cisco PTZ Installation Manual page 37

Chapter 4 Managing the Camera
Table 4-7
Control
Preset & Home Position
Note
Speed Control
OL-28954-01
Pan/Tilt/Zoom Settings (continued)
Click on the title to access these controls.
Description
You can configure a maximum of eight preset positions.
To add a preset position
Click on the plus button.
•
Enter a unique name for this preset position. The name can
•
contain from 1 to 64 characters, which can be letters,
numbers, and special characters, but no spaces. Special
characters are: ! % ( ) , - = @ _
Click the Save button.
•
If you already configured the maximum amount of preset
positions, an error message displays.
To delete a preset position, use the trash button.
You cannot delete a preset position that is part of a
Note
patrol list. Go to Patrol Settings to remove a preset
position from the patrol list.
To set one of the preset positions as the home position, click the
Set Current Home Position button.
To restore the default home position, click the Restore default
Home Position button.
Pan Speed—Use the slider to set the rate at which the camera
pans to the desired location. Values are 1 through 100. Default
is 50.
Tilt Speed—Use the slider to set the rate at which the camera
tilts. Values are 1 through 100. Default is 50.
Zoom Speed—Use the slider to set the rate at which the camera
zooms. Values are 1 through 100. Default is 50.
Focus Speed—Use the slider to set the rate at which the camera
focuses on a desired location. Values are 1 through 100. Default
is 50.
Auto Pan/Patrol Speed—Use the slider to set the rate at which
the camera automatically pans and patrols based on the patrol
list. Values are 1 through 100. Default is 50.
Cisco Video Surveillance PTZ IP Camera Installation Guide
Viewing Live Video
~
4-11