Installing the PTZ IP Camera
Cabling Through Waterproof Connectors
Perform the following steps to install and connect an external power cable and I/O cables for external
devices:
Disassemble the components of the waterproof connector into parts (A)–(E).
Step 1
Remove the plastic stopper from the bottom of the dome cap and keep the M20 hex nut.
Step 2
Depending on the number of wires, remove seals (C) from the rubber seal (B).
Step 3
Feed the power cable through the waterproof connector (E --> D --> B --> A). Be sure to feed enough
Step 4
power cable length through the waterproof connector to connect the power cable to the GPIO block.
Cisco Video Surveillance PTZ IP Camera Installation Guide
2-4
The recommended cable gauge is 1.2–1.8 mm.
There are 16 holes on the seal (B), and the widest holes with a crack on the side are specific
Note
for power cables.
Screw Nut (A)
Seal (B)
Seals (C)
Housing (D)
Sealing Nut (E)
Chapter 2
Installing the Camera
OL-28954-01