Bosch B450 Installation & Operation Manual page 33

Conettix Plug-in Communicator
Interface
Notice!
To allow the receipt of SMS data, the bus address switch must be set at position 0. Refer to
the tables in this section for LED activity.
If the bus address switch is not set to 0, incoming SMS data is discarded.
Enter CONFIG MODE
Ensure that the bus address switch is set to 0.
Compose the Configuration SMS
Use the appropriate SMS template for the selected mode of operation, and compose the
configuration SMS message on your mobile phone. SMS can contain only 160 characters.
Refer to Multiple SMS Messages (for Messages Longer than 160 Characters) for instructions
for sending a multiple SMS configuration.
The templates below contain only the essential configuration IDs. For additional configuration
IDs, refer to the SMS configuration parameters.
Notice!
Separate each ID or value pair with a semi-colon ; (for example, %1;1=B450;19=1;!). To allow
spanning of configuration across multiple messages, each SMS starts with the sequence
number followed by the command line separator.
Use the ! character to signal the end of the configuration data. Refer to your cellular phone's
documentation for available characters. You must include the current SMS configuration
passcode in the SMS text message to allow the module to save the new configuration data.
SMS configuration parameters
ID
1=
2=
Basic parameters
13=
15=
16=
19=
20=
Bosch Security Systems, Inc.
Description
Current passcode (4 to 10 characters); default = B450
New passcode (4 to 10 characters)
TCP/UDP port number: 7700 (1 to 65535)
AES encryption
– 0 = disable
– 1 = 128 bit
– 2 = 192 bit
– 3 = 256 bit
AES encryption key (0 to 9, A-F, a-f, based on key size,
none, 32, 48, or 64 digits)
Tamper (V1.0.x control panels on SDI2 bus)
– 0 = disable
– 1 = enabled
SMS configuration
– 0 = disabled
– 1 = enabled
Installation and Operation Guide
Configuration | en 33
2013.09 | 02 | F.01U.282.875