Bosch B450 Installation & Operation Manual page 30

30 en | Configuration
Option Press
to
Select
3. Reset Status 3
4. Signal 4
Strength
4. Product 5
Versions
Table 5.3: Status sub-menu parameters
Diagnostic Log sub-menu parameters
For a description of the Diagnostic Log sub-menu parameters (Modify Diagnostic Settings, Re-
print All Console Messages, and Enable Console Messages), refer to the table below.
Notice!
The Diagnostic Log option is used in troubleshooting communication issues with the B450 .
Use of the Diagnostic Log option is to be used only at the direction of TECHNICAL SUPPORT.
Refer to Diagnostic log, page 41 for more information.
To go to a specific menu option, enter the appropriate menu item number to enter that item.
2013.09 | 02 | F.01U.282.875
Description
The status displays show several items that are counts of activities, such as UDP
packets transmitted. When reset status is selected, all counts are returned to zero.
This is not required for normal operation.
The current signal strength records every 15 minutes for up to 48 hours worth of
data. When signal strength is selected, up to 192 values are displayed representing
the signal strength values over the last 48 hours. If the B450 has been powered up
less than 48 hours, the list shows only the samples taken so far.
This option displays the software version of all entities in the B450. The following list
is an example of the versions displayed:
*** Product Versions ***
B450 Application: V 3.01.002
B450 Boot Loader: V 1.05.001
RTOS: V 3.03.500
Fusion Stack: V 8.07.3703
Cellular Manager: V 1.117.442
UPKI Encryption: V 3.03.002
AES Lib: V 01.00.000
Modem Firmware: V 15.00.021
Installation and Operation Guide
Conettix Plug-in Communicator
Interface
Bosch Security Systems, Inc.