Bosch B450 Installation & Operation Manual page 20

20 en | Configuration
Parameter
Tamper (for GV4 ([v1.0.x or
higher] control panels)
IPv4 DNS Server IP Address
Web access password
TCP/UDP Port Number
Alternate IPv4 DNS Server IP
Address
TCP Keep Alive Time
IPv4 Test Address
IPv6 Test Address
2013.09 | 02 | F.01U.282.875
Value
0 = Disabled
1 = Enabled
IPv4 address format (0.0.0.0)
Enter a 4 – 10 character
password to access module
programming Do not use the
characters ; or !
1 to 65535 (7700)
IPv4 address format (0.0.0.0)
0 – 255 sec (45)
IPv4 address format (0.0.0.0)
IPv6 address format (0.0.0.0)
Installation and Operation Guide
Conettix Plug-in Communicator
Interface
Description
When enabled, allows tamper
and tamper restore
conditions to be reported to
an SDI2 control panel.
Notice!
Only control panels with a
SDI2 bus connection to the
B450 can report a tamper
condition.
The B450 uses the DNS
server addresses supplied by
the cellular network when the
Primary DNS Server address
option is configured as
0.0.0.0. If the address is not
configured as 0.0.0.0, the
B450 installs the Primary DNS
Server address.
The web access password is
used to allow access to
module programming. For a
B450 module, the password
controls configuration from
the USB menu and SMS text.
Sets the source port for the
B450.
If the address is not
configured at 0.0.0.0, the
B450 installs the Alternate
DNS Server address.
This parameter determines
how long to wait between
transmissions to keep an idle
TCP connection to a remote
host from terminating due to
inactivity.
The IPv4 Test Address is used
by the module to ping an
internet address as part of
the IP diagnostics.
The IPv6 Test Address is used
by the module to ping an
internet address as part of
the IP diagnostics.
Bosch Security Systems, Inc.