Boot Device Options - Adaptec 2940U2W User Manual

SCSI Card 2940U2W User's Reference
Host Adapter SCSI Termination—Determines the termination
setting for the SCSI card. The default setting for both the
Ultra2-LVD/SE connector and Fast/Ultra-SE connector is
Automatic. We recommend that you leave this setting at
Automatic. If you want to manually change this setting for the
Fast/Ultra-SE connector, Table 2 lists the recommended
configurations.
Table 2. Host Adapter SCSI Termination Configuration
If SCSI Peripherals are Connected to These Fast/Ultra-SE
Connectors on the SCSI Card 2940U2W...
68-pin internal connector only
50-pin internal connector only
50-pin and 68-pin internal connectors

Boot Device Options

Boot Target ID—Specifies the SCSI ID of your boot device.
Boot LUN Number—Specifies which LUN (Logical Unit
Numbers) to boot from on your boot device. Multiple LUN
Support must be enabled (see Advanced Configuration Options
on page 20).
18
...Use this Setting
Low ON/High ON
Low ON/High ON
Low OFF/High ON