Adaptec 2940U2W User Manual page 13

An "X" inside a red circle appears with the SCSI Card 2940U2W
software driver in Device Manager. What does this mean?
The SCSI Card 2940U2W software driver is disabled and isn't load-
ing. To enable the driver:
1
Double-click the SCSI Card 2940U2W software driver in
Device Manager.
2
Under the General tab, check the Original Configuration (cur-
rent) box.
What if there is no SCSI controller icon under Device Manager, or the
software driver for the SCSI Card 2940U2W does not appear under
Device Manager?
If the SCSI controllers icon or the software driver do not appear:
1
Double-click the Add New Hardware icon in Control Panel.
2
Select Yes on the second screen of the Add New Hardware
Wizard to have Windows search for the SCSI Card 2940U2W.
3
Follow the onscreen instructions.
If Windows 95 does not detect the SCSI Card 2940U2W, run the Add
New Hardware Wizard again:
1
Double-click the Add New Hardware icon in Control Panel.
2
Select No on the second screen of the wizard.
3
Select SCSI controllers on the next screen.
4
Select "Adaptec AHA-2940U2W PCI Ultra2 SCSI Controller."
If "Adaptec AHA-2940U2W PCI Ultra2 SCSI Controller" is not on
the list, you may be able to install the driver from the Adaptec
EZ-SCSI Setup Diskette. Follow these steps:
1
Place the Adaptec EZ-SCSI Setup Diskette in the floppy disk
drive.
2
Double-click the Add New Hardware icon in Control Panel.
3
Select No on the second screen of the wizard.
4
Select SCSI controllers on the next screen.
5
Click the Have Disk button, then click the Browse button.
Troubleshooting
7