Adaptec 2940U2W User Manual page 27

Configuring the SCSI Card 2940U2W with SCSISelect
Boot Only—Only the removable-media drive designated
as the boot device is treated as a hard disk drive.
All Disks—All removable-media drives supported by the
BIOS are treated as hard disk drives.
Disabled— No removable-media drives are treated as hard
disk drives. Software drivers are required because the
drives are not controlled by the BIOS.
Caution:
Do not remove a removable-media cartridge from a
SCSI drive controlled by the SCSI card BIOS while the drive
is on. You may lose data. To allow removability of the media
while the drive is on, install the removable-media software
driver and set Support Removable Disks Under BIOS as
Fixed Disks to Disabled.
Display <Ctrl> <A> Messages during BIOS Initialization—
When set to Enable, the SCSI card BIOS displays the Press
<Ctrl> <A> for SCSISelect (TM) Utility! message on your screen
during system bootup. If this setting is disabled, you can still
invoke the SCSISelect Utility by pressing <Ctrl> <A> after the
SCSI card BIOS banner appears.
BIOS Support for Bootable CD-ROMs—When set to Enable,
the SCSI card BIOS allows booting from a CD-ROM drive.
BIOS Support for Int 13 Extensions—When set to Enable, the
SCSI card BIOS supports Int 13h extensions as required by
Plug-and-Play. The setting can be either enabled or disabled if
your system is not Plug-and-Play.
21