Adaptec 2940U2W User Manual page 12

SCSI Card 2940U2W User's Reference
6
Verify an IRQ is available by viewing resources in System
Properties.
7
Verify the Operating System is set to Optimal Performance by
checking the Performance tab under System Properties.
How can I tell if the SCSI Card 2940U2W software driver is loading
properly?
1
Click the Start button, point to Settings, then click Control
Panel.
2
Double-click the System icon.
3
Click the Device Manager tab.
4
Double-click the SCSI Controller icon. The software driver for
the SCSI Card 2940U2W is listed as "Adaptec AHA-2940U2W
PCI Ultra2 SCSI Controller."
If the driver is listed, the SCSI Card 2940U2W driver is
loading properly.
If the driver is listed but has an exclamation mark inside a
yellow circle, the software driver may be in conflict with
other hardware using the same resources. Double-click the
icon to see the device status and possible solutions.
If the driver is listed but has an "X" inside a red circle, the
SCSI Card 2940U2W software driver is disabled and isn't
loading (see below).
If the SCSI Controller icon or the SCSI Card 2940U2W soft-
ware driver is not listed, reinstall the driver (see below).
Note:
Software upgrades (including downloadable drivers)
for Adaptec products are available on the Adaptec Web Site
at http://www.adaptec.com .
6