Configuring The Scsi Card 2940U2W With Scsiselect - Adaptec 2940U2W User Manual

Configuring the SCSI Card
2940U2W with SCSISelect
SCSISelect, included with the SCSI Card 2940U2W, enables you to
change SCSI settings without opening the computer or handling the
card. SCSISelect also enables you to low-level format or verify the
disk media of your SCSI hard disk drives. Table 1 lists the available
and default settings for each SCSISelect option.
Note:
The default settings are appropriate for most systems.
Run SCSISelect if you need to change or view current set-
tings, or if you would like to run the SCSI disk utilities. See
the descriptions of each option on page 17.
SCSI Select Option
Basic Host Adapter Settings:
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination:
Ultra2-LVD/SE Connector
Fast/Ultra-SE Connector
Boot Device Settings:
Boot SCSI ID
1
Boot LUN Number
SCSI Device Configuration:
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation

Configuring the SCSI Card 2940U2W with SCSISelect

Table 1. SCSI Select Settings
Available Settings
0-15
Enabled, Disabled
Automatic, Enabled,
Disabled
Automatic,
Low ON/High ON,
Low OFF/High OFF,
Low OFF/High ON
0-15
0-7
Yes, No
80.0, 53.4, 40.0,
32.0, 26.8, 20.0,
16.0, 13.4, 10.0
Yes, No
Yes, No
Default Setting
7
Enabled
Automatic
Automatic
0
0
Yes (Enabled)
80.0
Yes (Enabled)
Yes (Enabled)
15