Table of Contents
Advertisement
Installing Your Controller
In this Chapter
Configuring SCSI Devices
Installing the Controller
Creating an Array Using SMOR
Determining the Booting Controller
Configuring SCSI Devices
When configuring devices for Adaptec ZCR controllers, you may
need to:
Decide how to position drives on the SCSI bus.
■
Select cables.
■
Enable or disable SCSI termination.
■
Set the SCSI IDs.
■
Note: SCSI drives should, in general, not be reformatted.
However, if your SCSI drive was formatted to a sector size
other than 512 bytes, you must reformat the drive before you
can use it in a RAID. Refer to the Adaptec Storage Management
Software User's Guide for details.
2
2-1
2-5
2-6
2-7
2-1
Advertisement
Table of Contents
