Configuring The Scsi Card 2940Uw Pro With Scsiselect - Adaptec 2940UW User Manual

Configuring the SCSI Card 2940UW Pro with SCSISelect

Configuring the SCSI Card
2940UW Pro with SCSISelect
SCSISelect, included with the SCSI Card 2940UW Pro, enables you to
change SCSI settings without opening the computer or handling the
card. SCSISelect also enables you to low-level format or verify the
disk media of your SCSI hard disks. Table 1 lists the available and
default settings for each SCSISelect option.
Note:
The default settings are appropriate for most systems.
Run SCSISelect if you need to change or view current
settings, or if you would like to run the SCSI disk utilities.
See the descriptions of each option starting on page 16.
Table 1. SCSI Select Settings
SCSI Select Options
Basic Host Adapter Options:
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination:
Narrow Connector
Wide Connector
Boot Device Options:
Boot Target ID
1
Boot LUN Number
SCSI Device Configuration Options:
Sync Transfer Rate (MBytes/sec)
Initiate Wide Negotiation
Enable Disconnection
Send Start Unit Command
Enable Write Back Cache
BIOS Multiple LUN Support
Default
Available Settings Setting
0-15 7
Enabled, Disabled Enabled
Enabled, Disabled Enabled
Automatic, Enabled, Automatic
Disabled
0-15 0
0-7 0
40.0, 32.0, 26.8, 20.0, 40.0
16.0, 13.4, 10.0, ASYN
Yes, No Yes (Enabled)
Yes, No Yes (Enabled)
Yes, No Yes (Enabled)
Yes, No, N/C N/C (No
Change)
Yes, No No (Disabled)
13