Rear Panel - Pioneer DV-545 Operating Instructions Manual

Rear Panel

1
CONTROL
VIDEO OUT
S
IN
5
1
CONTROL IN jack
Use to connect this player to another component
bearing the Pioneer Î mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connect to (page 16).
2
AV CONNECTOR
AV CONNECTOR 1 (RGB)-TV
Use a 21-pin SCART cable to connect to a TV or
monitor compatible with this type of connection.
Both audio (2 channel stereo) and video (Video,
S-video, and RGB) signals are output from the AV
CONNECTOR 1 (RGB)-TV (page 16).
AV CONNECTOR 2
Use a 21-pin SCART cable to connect to a VCR (page
16).
3
AUDIO OUT jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (pages 13,
14).
4
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(page 13).
10
En
2
AV CONNECTOR 1 (RGB)-TV
6
3
AV CONNECTOR 2
AUDIO OUT
OPTICAL COAXIAL
R L
7
5
S-VIDEO OUT jack
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-Video jack.
(page 15).
You can switch between [S1] and [S2] S-video
output from the Setup menu (page 30).
6
VIDEO OUT jack
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability
(pages 13, 15).
7
DIGITAL OUT OPTICAL jack
Use to output the digital audio signal recorded on
discs. You can output the digital signal via the optical
output jack to an AV amplifier or receiver (page 14).
8
DIGITAL OUT COAXIAL jack
Use to output the digital audio signal recorded on
discs. You can output the digital signal via the coaxial
output jack to an AV amplifier or receiver (page 14).
4
DIGITAL OUT
8
AC IN