Group 0, Function 6-Kyz Parameter Selection - GE EPM 5300 Instruction Manual

9.9: Group 0, Function 6—KYZ Parameter Selection
NOTE: FUNCTION 6 applies only if Option -NL or -NL2 was ordered.
OPTION -NL: This option gives the meter 2 Relays and one KYZ pulse.
programmed to the below features.
Select a single parameter from Table 9-5 according to the EPM 5300P model being programmed.
OPTION -NL2: This option offers 3 distinct KYZ pulses instead of Relays.
Only three separate parameters may be selected: FUNCTION 6.0 (KYZ Port 0), FUNCTION 6.1 (KYZ
Port 1), and FUNCTION 6.2 (KYZ Port 2). The available parameters vary according to the EPM 5300P
model being programmed. For exact port positions see Installation Sections.
PARAMETER
APPLICABLE SELECTIONS: 5300P - +WH, -WH, VAH
To perform the KYZ Parameter Selection:
NOTE: Press MAX/MIN/LIMITS at any time to cancel before storing the last digit or switch.
MAX
MIN
LM1
LM2
KVAH KWH
MAX/MIN
VOLTS AMPS
LIMITS
Step 1:
a. Enter Group Level of Programming Mode
(see Chp. 8).
b. Press MAX/MIN/LIMITS until 0. appears in
upper display.
c. Press AMPS to activate the Group.
GE Multilin
CHAPTER 9: PROGRAMMING GROUP 0 – GLOBAL METER SETUP
0
1
2
3
4
5
Table 9-5: KYZ Parameters
5300P+R* - +WH, -WH, +VARH, -VARH
* (-R option gives the 5300P VAR/Hour readings instead or VA/Hours).
AC VOLTS
A B C A B C
N N N B C A
AC AMPS
A B C N
POWER
PF
KW
KVA
KVAR
FREQ
PHASE
POWER
NEXT
EPM 5000 series Advanced Power Meters
DESCRIPTION
Disable KYZ
Positive Watt Hour KYZ
VA Hour KYZ
Negative Watt Hour KYZ
Positive VAR Hour KYZ
Negative VAR Hour KYZ
MAX
MIN
LM1
LM2
KVAH KWH
MAX/MIN
VOLTS AMPS
LIMITS
Step 2:
a. Press MAX/MIN/LIMITS until 06.P appears in
upper display.
(Standard Selection is 1).
The KYZ pulse can be
AC VOLTS
A B C A B C
N N N B C A
AC AMPS
A B C N
POWER
PF
KW
KVA
FREQ KVAR
PHASE
POWER
NEXT
55