Chapter 15: Programming Quick Reference; Entering The Programming Mode; Data Entry Sequence; Programming Groups - GE EPM 5300 Instruction Manual

CHAPTER 15
PROGRAMMING QUICK REFERENCE

15.1: Entering the Programming Mode

1. Hold PHASE/NEXT key and press AMPS key.
2. Display blanks and shows either a '0',
'1', or '3'.
3. If '3' is not displayed then press AMPS key until '3' is displayed.
4. Release AMPS key and press PHASE/NEXT key, while '3' is still displayed.
5. Display shows '333' momentarily.
6. Upper display starts counting. Press PHASE/NEXT key when '5' is displayed to register the '5'.
7. Repeat step 6 until '555' has been registered.

15.2: Data Entry Sequence

1. At programmable numerical fields or Switch Pack fields, Press AMPS key to begin Data Entry
Sequence.
2. The current setting moves to middle row of display and dashes appear in the bottom row. Press
VOLTS key to toggle between available choices.
3. When a correct choice is selected, press AMPS key to store.

15.3: Programming Groups

Programming
groups
0
1
2
3
4
5
6
7
8
GE Industrial Systems

CHAPTER 15: PROGRAMMING QUICK REFERENCE

Global Meter Setup—Integration Interval, Meter Address,
Communication Setting, Relay Settings
Full Scale Settings. Voltage Full Scale, Current Full Scale and Power
Function Full Scale.
Meter Calibration
Calibration Ratios
Volts and Current Limits
Power Function Limits
THD Limits
Imbalance Reversal Limits
DC Output Calibration
5300P Advanced Power Meter
Description
85