Weider 245 Bench User Manual page 10

15. Insert a Short Pad Tube (35) into the Left Fly Arm
(10), and slide a Small Foam Pad (26) onto the
Short Pad Tube.
Repeat this step for the other side of the
weight bench.
16. Attach the Curl Pad (20) to the Curl Post (9) with
two M6 x 16mm Screws (61).
17. Route the Cable (21) through the top of the Lat
Tower (14); make sure that the Cable passes
under the storage hook. Next, wrap the Cable
over the Pulley (22) and attach the Pulley to the
Lat Tower with an M10 x 60mm Bolt (57), two
M10 Black Washers (64), two 16mm x 10mm
Spacers (52), and an M10 Black Nylon Locknut
(66).
Insert an M10 x 20mm Bolt (63) into the bracket
on the Weight Carriage (15). Next, slide the
Weight Carriage onto the Lat Tower (14). Then,
attach the Cable (21) to the Weight Carriage with
the Bolt and an M10 Black Nylon Locknut (66).
18. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in
ADJUSTMENTS, starting on page 11.
15
16
20
17
66 64
22
66
10
10
35
26
9
61
Storage
52
Hook
52
64
57
21
14
63
15