MANAGED 8-PORT 10/100 + 2 G DUAL PERSONALITY SWITCH
2.7
Bandwidth Control
Use this screen to define a maximum allowable bandwidth for incoming and/or outgoing
traffic flows on each port of the Switch.
Click on each parameter field to modify the desired setting, then click Apply to retain
newly entered information or click Undo to restore previously saved configurations.
NOTE: The maximum limited rate for the last 2 ports (the Gigabit ports) is 1000Mbps,
while the maximum limited rate for the eight 10/100TX ports is 100Mbps.
Parameter
Port Number
Rate Level
Rate Limit
Active
Description
Select the port number you are going to configure.
Select the level of limited ingress/ egress traffic for each port.
Set the rate limit in the correspondent rate level. Each unit is ten steps.
Enable or disable the bandwidth control on each port.
23