Autohome Recalibration Operation; Using The Autohome Recalibration - Bosch VG5 600 Series User Manual

54 en | Advanced Features
7.9.1

AutoHome Recalibration Operation

Recalibration occurs when the AutoDome loses its home position or after the specified time
interval has elapsed. Once a recalibration event occurs, the AutoDome will delay the start of
the recalibration for15 minutes to ensure that all manual commands have ceased. Manual
control is defined as a pan or tilt movement.
If after the initial 15-minute delay the AutoDome is still under manual control, the unit delays
the start of recalibration for another 15 minutes.
It is recommended to set the Inactivity (AUX ON 9) to Shot 1 or to Previous AUX so the
AutoDome returns to a preset position or starts a tour after the recalibration process is
complete.
The AutoHome recalibration behaves in the following manner under specific circumstances:
–
–
7.9.2

Using the AutoHome Recalibration

Use the following procedure for the initial setup of the AutoHome Recalibration:
1.
Setting
Status
Mode
Interval
Initial Offset
Number of Recals Total number of homing recalibrations performed due to loss of home or
Next Cal
2.
3.
4.
5.
F.01U.270.005 | 2.0 | 2012.06
AutoTracker
If the AutoDome is actively tracking an object with AutoTracker when the interval elapses
or a loss of home is detected, the unit will delay recalibration until the AutoTracker stops
tracking.
Preset or Recorded Tour
If the AutoDome is performing a preset or playback of a recorded tour when the interval
elapses or a loss of home is detected, the unit will start the recalibration process
immediately. If the Inactivity command (AUX ON 9) is set to Return to AUX, the unit will
resume the tour after the recalibration process is complete.
Issue the AUX ON 680 command to check the status of the recalibration settings. This
command displays a status screen that shows the following information:
Values
Enabled
Disabled
Loss
Loss + Interval
6 - 72 hours, in 6-hour increments
4 - 20 hours, in 4-hour increments
interval
Shows the days, hours, minutes, and seconds until the next homing
recalibration
Set the Recalibration Mode to recalibrate on the loss of home and after every interval:
– Issue the AUX ON 682 command.
– Issue the AUX ON 682 command again.
Note: The AUX ON 682 command must be issued twice only for the initial setup.
Each subsequent AUX ON 682 command toggles the mode as described in the table
above.
Set the Recalibration Interval by issuing the AUX ON 683 and the AUX OFF 683
commands. For example, to set the Recalibration Interval to 24 hours, issue the AUX ON
683 commands four times.
Set the Initial Offset Time by issuing the AUX ON 684 and the AUX OFF 684 commands.
For example, to set the Initial Offset Time to 8 hours, issue the AUX ON 684 command
twice.
Issue the AUX ON 681 command to enable the recalibration routine.
User Manual
AutoDome 600 Series Analog PTZ Camera
Bosch Security Systems, Inc.