Pelco On-Screen Menus; Setup Menu - Bosch VG5 600 Series User Manual

36 en | Pelco On-Screen Menus
5

Pelco On-Screen Menus

You can program the AutoDome through the Pelco on-screen display (OSD) menus. To access
the Pelco menus, you must configure the AutoDome for Pelco Mode and invoke the Pelco
main Setup Menu.
5.1

Setup Menu

The Pelco main Setup Menu provides access to the programmable AutoDome settings. Some
menu items are locked and require a system password to use. Menu items marked with an *
are the default settings.
To open the Pelco main Setup Menu (locked commands):
1.
2.
3.
4.
NOTICE!
Use Zoom to select the Exit item from anywhere in a menu.
Menu
Exit
Command Lock
(locked)
Bosch Menu (locked)
Camera Setup
PTZ Setup
Edit Password
(locked)
FastAddress (locked)
F.01U.270.005 | 2.0 | 2012.06
Press 95-PRESET (press the PRESET button for approximately 2 seconds to open).
Use the joystick to highlight a menu item.
Press either the Focus or the Iris key to open a menu item.
Follow the on-screen instructions at the bottom of the screen.
Setup Menu
Exit...
Command Lock:
Bosch Menu
Camera Setup
PTZ Setup
Edit Password
*FastAddress:
Advanced
Software Version
Ack and Reset Alarms
Restore All Settings
Reset All Memory
* = Factory Setting
Focus / Iris: Select
Description
Exits the menu.
Allows or prohibits accessing locked commands. (If password is
set, you are prompted to enter the password.
Accesses the full AutoDome configuration menu and all AutoDome
settings.
Accesses the White Balance and Night Mode camera settings.
Accesses the tours, tour periods, scan speed, edit presets, limit
stops, recording, and AutoPivot settings.
Changes the password.
Sets or changes a camera address.
OFF
Not Set
User Manual
AutoDome 600 Series Analog PTZ Camera
Bosch Security Systems, Inc.