Menu 1: Add, Edit Or Delete Rf Transmitter; Adding A New Rf Transmitter; Figure 15: Rf Transmitter Status - Bosch D8125INV Operation And Installation Manual

D8125INV
Installation

3.6.1.2 Menu 1: Add, Edit or Delete RF Transmitter

This menu is used to add/edit/delete RF transmitters to the D8125INV and to configure them.
The display for adding, editing or deleting an RF Transmitter is the same.
Figure 15 shows an example of the display.
1. The point address of the RF Transmitter.
2. The mode the RF Transmitter is in (see Section 3.6.1.1 Point
Mode, p.17 for more information).
3. The current check-in selection for that specific RF
Transmitter (see Section 3.6.1.3 Adding a new RF Transmitter,
p.18).
4. This line is used to display the key options for this transmitter (see Section 3.6.1.3 Adding a new RF
Transmitter, p.18).
<command scroll> = "Push 1 to edit" displays for 3 seconds, "2 to delete" displays for 3 seconds, "3 to
program" displays for 3 seconds or "ESC to exit" displays for 3 seconds
Function
Adding new
Adding existing
Deleting

3.6.1.3 Adding a new RF Transmitter

To add an RF transmitter, follow the steps below:
Complete the steps in Section 3.6.1 Beginning steps to add/edit/delete an RF Transmitter, p.16.
1.
After the point number has been entered, the keypad will display:
2.
Note: By default, all new points being added will be assigned Mode 4 and
have a check-in time of 1 minute.
Push [1] to edit the transmitter if the displayed values need to be
3.
modified. If not, proceed to step 8.
The display will change to the following:
4.
49690E
Used When...
adding new transmitter(s)
programming transmitter(s) and adding to
D8125INV
to change mode and/or check-in time of
transmitter(s)
adding the point to D8125INV without
reprogramming the transmitter(s)
replacing the D8125INV without reprogramming
the transmitter(s)
deleting transmitter(s) from the D8125INV
Table 7: RF Transmitter options
D8125INV Operation and Installation Guide
Page 18

Figure 15: RF Transmitter status

For more information...
Section 3.6.1.3 Adding a new
RF Transmitter, p.18
Section 3.6.1.3 Adding an
existing RF Transmitter, p.20
Section 3.6.1.4 Deleting an
RF Transmitter, p.21
© 2005 Bosch Security Systems