3.0
Installation
The D8125INV is packaged with a Point Label Sheet. Save these, as you will use them when identifying the
point numbers on the Inovonics transmitters.
3.1
Mounting the D8125INV
Select the knockout from the control panel enclosure
1.
that will be used to route the wiring.
Select the location from which the Inovonics FA400
2.
Receiver wiring will be routed.
Remove the base of the
3.
D8125INV and use the
screws provided with the unit
to mount it adjacent to the
control panel.
Connect the wiring (see
4.
Section 3.2 Wiring the
D8125INV to the Control
Panel and FA400 Receiver) to
the D8125INV and mount
the cover unit to the base.
© 2005 Bosch Security Systems
Figure 3: Mounting the D8125INV base
D8125INV Operation and Installation Guide
Page 11
Wire
Knockouts
Figure 2: Choosing a Knockout for Wiring
Routing (D8103 enclosure shown)
D8125INV
Control Panel
Enclosure
D8125INV
Installation
Base
49690E