Fa400 Receiver Supervision; Missing Transmitters; Low Transmitter Battery Conditions; Figure 20: Call For Service, Enter Code + Ent - Bosch D8125INV Operation And Installation Manual

Symptom
RF Keyfob transmitter points go
missing
RF points go missing when
programmed supervision interval
= none.
4.1

FA400 Receiver Supervision

The D8125INV supervises the Inovonics FA400 receiver by periodically polling it.
If the FA400 does not respond to the polls over a five minute period, the
D8125INV will initiate a Point Bus Trouble event back to the control panel. The
control panel will then initiate a Point Bus Fail 1 (or 2) event.
If this occurs, the D8125INV will display Figure 20.
Enter a valid passcode and then Figure 21 will be displayed.
4.2

Missing Transmitters

A transmitter may go missing in the system due to the following most common
reasons:
dead battery
physical environmental changes
damage to the transmitter
The D8125INV will display Figure 22.
Enter a valid passcode and then Figure 23 will be displayed.
Note: The number 019 (which is used as an example) refers to the actual
quantity of points missing, not the specific point number.
4.3

Low Transmitter Battery Conditions

When the transmitter reports low battery conditions and replacement is necessary be sure to press reset button on
transmitter after replacing battery. Also, be sure to test the transmitter for proper operation after replacing battery.
© 2005 Bosch Security Systems
Diagnosis
RF keyfobs may only be
programmed as points 74 & 75, or
as points 194 & 195. Since keyfobs
can be carried off-site, these points
are not supervised, regardless of
the programmed RF supervision
interval.
These RF Points are programmed
as Fire Points (transmitter modes
8-12). Transmitters programmed
as Fire points will be supervised at
4 hour intervals, regardless of
programmed supervision interval
time.
Table 11: Troubleshooting Solutions
D8125INV Operation and Installation Guide
Page 31
D8125INV
Troubleshooting
Remedy
Reprogram RF keyfob transmitters
as Points 74 & 75 (zonex 1), or
Points 194 & 195 (zonex 2).
If those RF points are not for Fire
devices, connect and reprogram
the transmitter as new, changing
the transmitter Mode to non-fire
(Modes 1-7).
Figure 20: Call for Service,
Enter Code + ENT
Figure 21: Call for Service, Receiver
Missing
Figure 22: Call for Service,
Enter Code + ENT
Figure 23: Call for Service, Receiver
Missing
49690E