D8125Inv Menu Selections; Beginning Steps To Add/Edit/Delete An Rf Transmitter; Figure 14: D8125Inv Menu Selections - Bosch D8125INV Operation And Installation Manual

D8125INV
Installation
3.6

D8125INV Menu Selections

After the passcode is entered and the [ENT] key is pressed, the first of the following menus are displayed with each menu
displayed for three seconds before the next one is displayed.
To select a function, press the corresponding number or function key displayed. This menu scrolls for 5 minutes. After 5
minutes the display returns to showing idle text if no keypad activity is detected.
It is highly recommended that a walk test be performed after all programming is completed.
3.6.1

Beginning steps to add/edit/delete an RF Transmitter

Follow the steps below to begin the process of adding a new or existing RF transmitter:
From the Idle Text screen, enter the passcode and press
1.
[ENT] to access the main menu.
Press 1 to add or edit an RF Transmitter (RF Xmtr).
2.
Enter the point number and press [ENT]
3.
At the Transmitter point status screen, do the following depending on the desired action:
4.
To edit mode (see Section 3.6.1.1 Point Mode) and/or check-in time for new transmitters, press 1 and
see Section 3.6.1.3 Adding a new RF Transmitter, p. 18 or to reprogram existing transmitters, see
Section 3.6.1.3 Adding an existing RF Transmitter, p.20.
To delete a transmitter from the D8125INV, press 2 and see Section 3.6.1.4 Deleting an RF Transmitter
p.21.
49690E

Figure 14: D8125INV Menu Selections

D8125INV Operation and Installation Guide
Page 16 © 2005 Bosch Security Systems