Rf System Ok; Call For Service; Factory Default Passcode; Entering Invalid Passcodes - Bosch D8125INV Operation And Installation Manual

3.5.2

RF System OK

If the system is OK, Figure 10 will appear.
3.5.3

Call for Service

If one of the following conditions occurs, Figure 11 will appear.
EEPROM Failed
Receiver Missing
Programmed RF Points Missing
see Section 4.0 Troubleshooting, p.29 for more information.
3.5.4

Factory Default Passcode

The D8125INV contains a single passcode. To access the functions in the
D8125INV, this passcode must be entered first. The default passcode loaded at
the factory is 123456 + [ENT]. This passcode may be changed at any time
from within programming mode. To enter the default passcode, press 123456
+ [ENT].

3.5.4.1 Entering Invalid Passcodes

If an invalid passcode is entered, the D8125INV keypad will display Figure 12.
If an invalid passcode is entered 4 times in row, the keypad will display Figure
13.
The D8125INV will disallow any further entries for 5 minutes, unless power is
cycled to the unit.
© 2005 Bosch Security Systems
D8125INV Operation and Installation Guide
Page 15
D8125INV
Installation

Figure 10: RF System Normal

Figure 11: Call for Service

Figure 12: Invalid code display

Figure 13: Invalid code, Keypad locked
display
49690E