Table of Contents
Advertisement
96
en | Appendix
Malfunction
No connection
established, no image
transmission.
The camera does not
report an alarm.
Control of pan/tilt or
other units is not
possible.
The camera is not
operational after a
firmware upload.
Placeholder with a red
cross instead of the
ActiveX components.
Web browser contains
empty fields.
The CONNECT LED
flashes red.
DOC | V4.5 | 2010.09
Possible causes
The unit's configuration.
Faulty installation.
Wrong IP address.
Faulty data transmission within
the LAN.
The maximum number of
connections has been reached.
Alarm source is not selected.
No alarm response specified.
The cable connection between
the serial interface and the
connected unit is not correct.
The interface parameters do not
match those of the other unit
connected.
Power failure during
programming by firmware file.
Incorrect firmware file.
JVM not installed on your
computer or not activated.
Active proxy server in network.
Firmware upload failed.
Installation and Operating Manual
Recommended solution
Check all configuration
parameters.
Check all cables, plugs, contacts
and connections.
Check the IP addresses
(terminal program).
Check the data transmission
with ping.
Wait until there is a free
connection and then call the
sender again.
Select possible alarm sources on
the Alarm Inputs configuration
page.
Specify the desired alarm
response on the Alarm
Connections configuration page,
change the IP address if
necessary.
Check all cable connections and
ensure all plugs are properly
fitted.
Make sure that the settings of all
units involved are compatible.
Have the unit checked by
Customer Service and replace if
necessary.
Enter the IP address of the unit
followed by /main.htm in your
Web browser and repeat the
upload.
Install Sun JVM from the
product CD.
Create a rule in the local
computer's proxy settings to
exclude local IP addresses.
Repeat firmware upload.
Bosch Sicherheitssysteme GmbH
VOT-320
Advertisement
Table of Contents
