Table of Contents
Advertisement
VOT-320
Pre-programmed profiles are available, each giving priority to different perspectives. Below is
a brief description of the factory default settings for the encoder profiles.
–
–
–
–
–
–
–
–
CAUTION!
Change the profiles only once you are fully familiar with all the configuration options.
In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections. Bear this fact in mind when assigning the profile.
NOTICE!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
Profile name
You can enter a new name for the profile. The name is then displayed in the Non-recording
profile list field on the Encoder Streams page in the lists of selectable profiles.
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal management.
Target bit rate
You can limit the bit rate for the VOT-320 to optimize utilization of the bandwidth in your
network. The target bit rate should be set according to the desired picture quality for typical
scenes with no excessive motion.
For complex images or frequent changes of image content due to frequent movements, this
limit can be temporarily exceeded up to the value entered in the Maximum bit rate field.
Maximum bit rate
This maximum bit rate is not exceeded under any circumstances. Depending on the video
quality settings for the I and P-frames, this fact can result in individual images being skipped.
The value entered here must be at least 10% higher than the value entered in the Target bit
rate field. If the value entered here is too low, it will automatically be adjusted.
Bosch Sicherheitssysteme GmbH
High quality 1
For high bandwidth connections with IBBP GOP structure
High quality 2
For high bandwidth connections with IP GOP structure
Low bandwidth
For low bandwidth connections with lP GOP structure
DSL
For DSL connections with 500 kbps
ISDN (2B)
For ISDN connections via two B-channels
ISDN (1B)
For ISDN connections via one B-channel
MODEM
For analog modem connections with 20 kbps
GSM
For GSM connections at 9,600 baud
Installation and Operating Manual
Configuration using a Web browser | en
DOC | V4.5 | 2010.09
41
Advertisement
Table of Contents
