Satellite Configuration Installations; Satellite Site "Trunk Line" Monitor Outputs - Bosch LTC 8600 Instruction Manual

36 | en

10 Satellite Configuration Installations

10.1 Satellite Site "Trunk Line" Monitor Outputs

Bosch Security Systems, Inc.
Due to the many variations possible, only general guidelines can be covered for
installing satellite systems. Refer to the Appendix Section of this manual, the
LTC 8850/00 GUI Software manual, or the LTC 8059/00 MCS package manual for
additional configuration and programming information on satellite systems.
Satellite
System
#1
Satellite
System
#2
The central station can view/control cameras
located at any site. The satellite sites can view/
control cameras located only within their own
site.
Figure 10: Satellite Concept Configuration
At each of the remote satellite sites, a desired number of monitor outputs from the
switcher must be assigned as trunk lines. The number of trunk lines can range from
1 to the maximum number of monitor outputs provided by the switcher. Note that
the number of trunk lines coming from a satellite site determines the maximum
number of cameras from that site which may be viewed simultaneously at the main
site. If operators will be stationed at the satellite site, they should be prevented
from accessing the monitor outputs designated as trunk lines. This prevention can
be accomplished via the Monitor Lockout Tables in either the LTC 8059/00 MCS or
the LTC 8850/00 GUI Software (see below).
Instruction Manual
Central Control
Station
Satellite
System
#3
Satellite
System
#4
LTC 8600 | LTC 8800 Series
Satellite
System
#6
Satellite
System
#5
F.01U.127.393 | 2.0 | 2009.03