Bosch LTC 8600 Instruction Manual page 114

108 | en
Bosch Security Systems, Inc.
Allegiant
Satellite
Typical Master/Multiple Satellite Configuration
Allegiant
Master
Dual Master Configuration
Allegiant
Master
Allegiant
Master
Quadruple Master Configuration
Master can
Allegiant
view /control
Master
all cameras
Satellite/Master can view/control local and Satellite's cameras
'Cascaded' Satellite Configuration
Figure 22: Possible Allegiant Satellite System Configurations
Any Allegiant Series switcher model (LTC 8100, LTC 8200, LTC 8300, LTC 8500, LTC
8600, LTC 8800, or LTC 8900) can be used as a main site or a satellite site unit. All
products are standard models, and the only special requirement is to use either the
optional LTC 8059/00 MCS or the optional LTC 8850/00 GUI Software package for
initial programming of each Allegiant system.
An Allegiant biphase control data line from the code distribution unit at the Main
site must be provided to each satellite site. This data line carries all pan/tilt/zoom
control commands, in addition to the switching commands generated by the Main
site switcher. The control data line should be connected to a LTC 8780 Series Data
Converter to provide address decoding functions for the satellite site. If operators
at the satellite site are permitted to control pan/tilt/zoom-equipped cameras, a
Instruction Manual
Allegiant
Master
Allegiant
Allegiant
Satellite
Satellite
Allegiant
Satellite/
Master
LTC 8600 | LTC 8800 Series
Allegiant
Satellite
Satellite can view/
control only local
cameras
Both
Masters
Allegiant
can view/
Master
control all
cameras
Allegiant
Master
All Masters
can view/con-
trol all cam-
eras
Allegiant
Master
Satellite
can
view/
Allegiant
control
Satellite
only local
cameras
F.01U.127.393 | 2.0 | 2009.03