Recording Profiles - Bosch VG5 700 Series User Manual

AutoDome 700 Series IP PTZ Camera
5.
CAUTION!
If older recordings are not allowed to be overwritten when the available memory capacity has
been used, the recording in question will be stopped. You can specify limitations for
overwriting old recordings by configuring the retention time (see Section 4.35 Retention Time,
page 46).
Formatting Storage Media
You can delete all recordings on a storage medium at any time.
CAUTION!
Check the recordings before deleting and back up important sequences on the computer's
hard drive.
1.
2.
3.
4.
Deactivating Storage Media
You can deactivate any storage medium from the Managed storage media list. It is then no
longer used for recordings.
1.
2.
4.34

Recording Profiles

You can define up to ten different recording profiles. You will then use these recording
profiles in the recording scheduler, where they are linked with the individual days and times
(see Section 4.36 Recording Schedule, page 47).
NOTICE!
You can change or add to the recording profile description on the tabs on the Recording
Scheduler page (see Page 47).
1.
2.
3.
4.
Standard recording
Here you can select the mode for standard recordings.
If you select Continuous, the recording proceeds continuously. If the maximum memory
capacity is reached, older recordings will automatically be overwritten. If you select the Pre-
alarm option, recording will only take place in the pre-alarm time, during the alarm and during
the set post-alarm time.
If you select Off, no automatic recording takes place.
Bosch Security Systems, Inc.
Check the boxes for the Overwrite older recordings option to specify which older
recordings can be overwritten once the available memory capacity has been used.
Recording 1 corresponds to Stream 1, Recording 2 corresponds to Stream 2.
Click a storage medium in the Managed storage media list to select it.
Click the Edit button below the list. A new window will open.
Click the Formatting button to delete all recordings in the storage medium.
Click OK to close the window.
Click a storage medium in the Managed storage media list to select it.
Click the Remove button below the list. The storage medium is deactivated and removed
from the list.
Click one of the tabs to edit the corresponding profile.
If necessary, click the Default button to return all settings to their default values.
Click the Copy Settings button if you want to copy the currently visible settings to other
profiles. A new window will open and you can select the profiles in which you want to
copy the settings.
For each profile, click the Set button to save the settings in the unit.
Configuring the AutoDome 700 Series | en
User Manual
45
F.01U.273.798 | 3.0 | 2012.08