Encoder Profile - Bosch VG5 700 Series User Manual

Autodome 700 series ip ptz camera
Table of Contents

Advertisement

AutoDome 700 Series IP PTZ Camera
CAUTION!
The AutoDome disables the Privacy Mask function if the orientation is set to Inverted.
SC Settings
Click the Default button to restore all camera settings to their original defaults.
SC Data
Click the default button to clear all preposition, privacy mask, and other user settings.
Reboot Device
Performs a reboot of the AutoDome. There is a ten (10) second pause before the dome starts
its homing phase. During the homing phase the camera pans left and right and tilts up and
down. It also adjusts the lens focus. The entire homing phase lasts approximately 40 seconds.
Factory defaults
Click Restore all defaults to restore the factory defaults for the camera. A confirmation
screen appears. Allow 5 seconds for the camera to optimize the picture after a mode reset.
4.19

Encoder Profile

For the video signal encoding, you can select a code algorithm and you can change the presets
for the profiles.
You can adapt the video data transmission to the operating environment (for example network
structure, bandwidth, data load). To this end, the AutoDome 700 Series simultaneously
generates two data streams (Dual Streaming), which compression settings you can select
individually, for example one setting for transmissions to the Internet and one for LAN
connections.
Pre-programmed profiles are available, each giving priority to different perspectives.
Bosch Security Systems, Inc.
High resolution 1
Target bit rate: 2000 kbps
Maximum bit rate: 4000 kbps
Encoding interval: 30.00 ips
High resolution 2
Target bit rate: 1500 kbps
Maximum bit rate: 3000 kbps
Encoding interval: 30.00 ips
Low bandwidth
Target bit rate: 700 kbps
Maximum bit rate: 1500 kbps
Encoding interval: 30.00 ips
DSL
Target bit rate: 400 kbps
Maximum bit rate: 500 kbps
Encoding interval: 30.00 ips
ISDN (2B)
Target bit rate: 80 kbps
Maximum bit rate: 100 kbps
Encoding interval: 30.00 ips
Configuring the AutoDome 700 Series | en
User Manual
33
F.01U.273.798 | 3.0 | 2012.08

Advertisement

Table of Contents
loading

Table of Contents