Advanced - Bosch VG5 700 Series User Manual

60 en | Configuring the AutoDome 700 Series
Force registration now
You can force the registration by transferring the IP address to the DynDNS server. Entries
that change frequently are not provided in the Domain Name System. It is a good idea to force
the registration when you are setting up the device for the first time. Only use this function
when necessary and no more than once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the AutoDome 800 Series, click the Register
button.
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
4.50

Advanced

The settings on this page are used to implement advanced settings for the network.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
SNMP
The AutoDome 700 Series supports the SNMP V2 (Simple Network Management Protocol) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code. If you wish to send SNMP
traps, enter the IP addresses of one or two required target devices here.
If you select On for the SNMP parameter and do not enter an SNMP host address, the
AutoDome 700 Series does not send them automatically, but only replies to SNMP requests. If
you enter one or two SNMP host addresses, SNMP traps are sent automatically. Select Off to
deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
SNMP traps
You can select which traps are to be sent.
1.
2.
3.
Authentication
If a RADIUS server is employed in the network for managing access rights, authentication
must be activated here to allow communication with the unit. The RADIUS server must also
contain the corresponding data.
To configure the unit, you must connect the AutoDome 700 Series directly to a computer
using a network cable. This is because communication via the network is not enabled until the
Identity and Password parameters have been set and successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying the AutoDome 700 Series.
Password
Enter the password that is stored in the RADIUS server.
F.01U.273.798 | 3.0 | 2012.08
Make the desired changes.
Click the Set and Reboot button. The AutoDome 700 Series is rebooted and the changed
settings are activated.
Click Select. A list is opened.
Click the checkboxes to select the required traps. All the checked traps will be sent.
Click Set to accept the selection.
User Manual
AutoDome 700 Series IP PTZ Camera
Bosch Security Systems, Inc.