Display Angle Adjustment; Adjusting Volume/Balance (Between Left And Right)/Fader (Between Front And Rear); Automatic Position Display - Alpine INA-N333R Owner's Manual

Gps car navigation/cd receiver
Table of Contents

Advertisement

Basic Operation
NAV.

Display Angle Adjustment

The movable display may be adjusted to 3 different
angles depending upon user preference.
1
Press the TILT
button to adjust the angle of the
movable display.
NOTES
• The display will close a half minute after the ignition key is
turned to the OFF position.
• The adjusted angle of the display is stored in memory. There
is no need to re-adjust the angle when the power is turned
back on.
CAUTION
Keep hands (or any other object) away from the display while it
is opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Adjusting Volume/Balance (Between
Left and Right)/Fader (Between Front
and Rear)
1
Press the MODE (Audio Control) knob repeatedly to
choose the desired mode.
Each press changes the modes as follows:
*
Vol.
MIX
SUBW.
Volume: 0 ~ 35
Balance: L15 ~ R15
Fader: F15 ~ R15
Subwoofer: 0 ~ 15
Mix level: 0 ~ 15
6
-EN
MODE
TILT
Movable display
*
FAD.
Vol.
BAL.
NOTES
• If the MODE (Audio Control) knob is not rotated within 5
seconds after selecting the BALANCE, or FADER mode, the
unit automatically returns to the VOLUME mode.
•* When the NAVI MIX (page 20), subwoofer (page 19) is ON,
respective levels may be adjusted.
2
Turn the MODE (Audio Control) knob until the desired
sound is obtained in each mode.
NOTE
When the temperature inside the unit rises, the volume may
decrease momentarily. This is not a malfunction.

Automatic Position Display

1
Press the NAV. button to change the display. Automatic
position (present position) and the GPS receiving
sensitivity are displayed.
Example of vehicle's present position
The GPS receiving sensitivity and the
number of satellites are displayed.
NOTES
• To display the present position of your vehicle, connect the
GPS antenna to the unit. (Refer to "Installing the GPS
Antenna" on page 39.).
• When inserting the separately sold navigation disk (NVD-
T003) specialized for this unit, navigating operations from the
unit become available. MENU, VOICE and TMC button are
used for navigating operations.

Advertisement

Table of Contents
loading

Table of Contents