Turning Power On And Off; Display Angle Adjustment; Subwoofer On And Off - Alpine CDM-7870R Owner's Manual

Basic
Basic Operation

Turning Power On and Off

1
Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button
except the c button.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press the POWER button for more than 3
seconds to turn off the unit.
NOTE
The very first time the power is turned on, the volume will
start from level 12, the BBE will be on in the tuner mode.

Display Angle Adjustment

The movable display may be adjusted to 3
different angles depending upon user preference.
1
Press the ANGLE button to adjust the angle of
the movable display.
NOTES
The display will close a half minute after the ignition
key is turned to the OFF position.
The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the
power is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
6
-EN
6 6 6 6 6
POWER BAND MODE / BBE
5 5 5 5 5
g DN f UP
Movable display
SETUP
ANGLE

Subwoofer On and Off

1
Press and hold the SETUP button for at least 3
seconds.
2
Press the g DN or f UP button to select
the SUB mode.
FM LV
3
Press the BAND button to select SUB-W ON or
SUBW OFF.
4
After setting is completed, press the SETUP
button to return to normal mode.
NOTES
Initial mode is "SUB-W ON."
Set to "SUBW OFF" unless the subwoofer is used.
When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer
to the Adjusting Volume/Balance/Fader section on
page 7.
c
REG SUB
AUX 100kHz/50kHz