Display Angle Adjustment; Subwoofer On And Off; Adjusting Source Signal Levels; Adjusting Volume/Balance (Between Left And Right)/Fader (Between Front And Rear) - Alpine TDM-7590R Owner's Manual

Display Angle Adjustment

The movable display may be adjusted to 3
different angles depending upon user preference.
1
Press the ANGLE button to adjust the angle of
the movable display.
NOTES
• The display will close a half minute after the ignition
key is turned to the OFF position.
• The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the
power is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.

Subwoofer On and Off

1
Press and hold the SETUP button for at least 3
seconds.
2
Press the g DN or f UP button to select
the SUB mode.
→ FM LV ←→ REG ←→ SUB ←
→ AUX ← → 100kHz/50kHz ←
3
Press the BAND button to select SUB-W ON or
SUBW OFF.
4
After setting is completed, press the SETUP
button to return to normal mode.
NOTES
• Initial mode is "SUB-W ON."
• Set to "SUBW OFF" unless the subwoofer is used.
• When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer
to the Adjusting Volume/Balance/Fader section on
page 5.
Movable display

Adjusting Source Signal Levels

If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the g DN or f UP button to select
the FM signal level mode.
→ FM LV ←→ REG ← → SUB ←
→ AUX ← → 100kHz/50kHz ←
3
Press the BAND button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and CD player and
cassette player closer.
4
After setting is completed, press the SETUP
button to return to normal mode.
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1
Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
→ VOL → BAL
NOTES
• If the 5 or 6 button is not pressed in 5 seconds after
selecting the BAL, or FAD mode, the unit
automatically sets in the VOL mode.
• When the subwoofer, BBE mode is set to ON, the
level of the subwoofer, BBE can be adjusted.
2
Press the 5 5 5 5 5 or 6 6 6 6 6 button until the desired sound is
obtained in each mode.
Basic
FR
ES
DE
→ FAD
IT
SE
5
-EN