Turning Power On And Off; Display Angle Adjustment; Adjusting Volume/Balance(Between Left And Right)/Fader (Between Front And Rear); Selecting Bbe Mode - Alpine TDA-7592R Owner's Manual

Turning Power On and Off

1
Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
The volume level gradually increases to the previous
level you were listening to before the unit was turned
off. Press and hold the POWER button for at least 3
seconds to turn off the unit.
NOTE
The very first time the power is turned on, the volume
will start from level 12, the BBE will be on in the tuner
mode.

Display Angle Adjustment

The movable display may be adjusted to 3
different angles depending upon user preference.
1
Press the ANGLE 89 button to adjust the angle
of the movable display.
NOTES
• The display will close a half minute after the ignition
key is turned to the OFF position.
• The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the power
is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
Movable display
Adjusting Volume/Balance
(Between Left and Right)/Fader
(Between Front and Rear)
1
Press the MODE (Audio Control) knob
repeatedly to choose the desired mode.
Each press changes the modes as follows:
→ BAL → FAD
NOTES
• If the MODE (Audio Control) knob is not rotated
within 5 seconds after selecting the BALANCE, or
FADER mode, the unit automatically returns to the
VOLUME mode.
• When the subwoofer or BBE mode is ON, their
respective levels may be adjusted.
2
Rotate the MODE (Audio Control) knob until the
desired sound is obtained in each mode.
NOTE
When the temperature inside the unit rises, the volume
may decrease momentarily. This is not a malfunction.

Selecting BBE Mode

The BBE (Barcus Berry Electronics) processor
installed in this unit is designed to correct the
phase distortion inherent in most loudspeaker
designs. Ensuring the phase integrity of the signal
driving the speakers improves the accurate
reproduction of the sound.
1
Press and hold the BBE button for at least 2
seconds to turn on and off the BBE mode.
2
In BBE mode, press the MODE (Audio Control)
knob to select the BBE adjusting mode.
Each press changes the adjusting mode.
3
To change to a desired BBE level, rotate the
MODE (Audio Control) knob.
The BBE level can be changed from +1 to +3.
NOTE
The initial mode is +2.
Basic
→ VOL
5
-EN