Table of Contents
Advertisement
MobileHub
BAND/TEL.
RTN
About MobileHub™ Link (Optional)
Connect a separately sold Junction Box and a portable
telephone (available from Nokia) to control the incoming
and outgoing calls of the portable telephone.
About Icon Indicator
Signal strength indicator: Telephone signal
strength is displayed at 4 levels.
Unread mail icon indicator: lights when there is an
unread short message.
Missed call icon indicator: lights when there is a
missed call.
CAUTION
• Even with hands-free operation, a driver can be distracted
during telephone operation or receiving a call. For the sake of
safety, drivers are requested to refrain from operating the
telephone while driving.
• For the sake of safety, operations other than incoming calls
and Speed-Dial outgoing calls cannot be used.
NOTES
• If a portable telephone is connected, its address book,
incoming and outgoing history, short message history are
downloaded to the Junction Box.
• Please refer to the instruction manual of the Junction BOX.
Telephone Mode On and Off
1
Press and hold the BAND/TEL. button for at least 2
seconds.
After the Network Operator display is shown for about
2 seconds, the display changes to the Speed Dial
screen.
See relevant pages for each item.
Press and hold the BAND/TEL. button for at least 2
seconds or press the RTN button to cancel the
telephone mode.
TM
Link Operation (optional)
NOTES
• When a portable telephone is not connected, "NO PHONE"
is displayed for at least 2 seconds, then the mode returns to
the original source mode.
• When the portable telephone is taken off the Junction BOX
during an incoming or outgoing call, or during a hands-free
call, the call will be treated as an ordinary one by the
portable telephone.
• When there is an incoming call while the power of INA-
N333R is OFF, the power of INA-N333R will turn ON
automatically for a hands-free call.
• Even if the power of the portable telephone is OFF, when
INA-N333R is set to the telephone mode, the power of the
portable telephone will be turned ON.
• Even if the ACC power of the vehicle is turned OFF (even if
the engine is stopped) during a hands-free call, the call is not
disconnected, and an ordinary call by the portable telephone
is possible.
• If there is an incoming call during operation (except an
outgoing call or talking), operation mode will end and switch
to the incoming or talking mode.
• An outgoing call from a portable telephone is also possible.
However, you cannot perform different operations at the same
time from a portable telephone and INA-N333R as
malfunction can result.
• With a Junction BOX connected, outgoing and incoming
history will also be recorded in the portable telephone.
• The telephone volume can be adjusted from the INA-N333R .
The volume you set during the call is memorized, and is
automatically applied again on the next call.
• While telephoning, defeat is set to ON. When the call has
finished, the unit returns to your previous setting.
• In a status other than telephoning, receiving incoming calls or
making a call, press the TITLE button to show the Network
Operator display for 2 seconds.
• After a call, instead of going to a talking mode, the unit
displays the message "NO NETWORK COVERAGE" or
"BUSY" for about 2 seconds and then disconnects the line.
• Within 5 seconds after a call, press the
button or MODE knob to redial.
• During a call, you can send dial tone signals 1 to 6 using
preset buttons 1 through 6, and dial tone signals 7 to 9, 0,
and
#
by pressing F/SETUP, and then preset buttons 1
through 6.
• Pressing the OK button in the navigation mode (when
optional navigation disc NVD-T003 is used) will not allow
selection of message transmissions, item definitions, or items
obtained by moving the Flipper switch.
button, OK
*
29
-EN
Advertisement
Table of Contents
