Installation - Alpine INA-N333R Owner's Manual

Installation and Connections

Installation

Installing the Main Unit
Caution
When you install this unit in your car, do not remove the
Detachable Front Panel.
If the Detachable Front Panel is removed during installation, you
might press too hard and warp the metal plate that holds it in place.
Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit
and may cause a fire.
Air ventilation
hole
1
Bracket
Dashboard
Mounting sleeve
(Included)
Slide mounting sleeve from main unit (see "Removal"
on this page). Slide the mounting sleeve into the
dashboard.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the INA-N333R and put the
Rubber Cap on the hex bolt. If your vehicle does not
have the Mounting Support, reinforce the head unit
with the metal mounting strap (not supplied). Connect
all the leads of the INA-N333R according to details
described in the CONNECTION section.
38
-EN
Metal plate
Detachable
Front panel
<Rear side>
Rubber Cap
(Included)
Hex Bolt
(Included)
INA-N333R
Screw
Bolt Stud
∗
INA-N333R
NOTE
For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the INA-N333R into the dashboard. When the
unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the locking
pin down with a small screwdriver. This ensures that
the unit is properly locked and will not accidentally
come out from the dashboard. Install the Detachable
Front Panel.
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
INA-N333R
Lock pin
Front frame
Screws (M5 × 8)
(Included)
Mounting Bracket