Pi Seek Setting; Receiving Traffic Information; Pty (Programme Type) Tuning - Alpine INA-N333R Owner's Manual

RDS Operation
OK
TITLE
T.INFO/ANNC. F/SETUP

PI SEEK Setting

1
Press and hold the F/SETUP button for at least 2
seconds. The display changes to the SETUP screen.
2
Move the Flipper switch up or down to select PI
SEEK. Press the OK button or MODE knob to set.
3
Move the Flipper switch up or down to select ON or
OFF. Press the OK button or MODE knob to set. The
display returns to the SETUP screen.
4
Press the F/SETUP button again to return to normal
operation.

Receiving Traffic Information

1
Press the T.INFO/ANNC. button to activate the Traffic
Information mode.
To cancel the Traffic information mode, press the
T.INFO/ANNC. button again.
2
Press the or button to select your desired
traffic information station. When a traffic information
station is tuned in, the TP indicator lights up.
Traffic information is heard only when it is being
broadcast. If traffic information is not being broadcast,
the unit is set in the standby mode. When a traffic
information broadcast begins, the unit automatically
receives it and the display shows "T.INFO".
When traffic information broadcast is over, the unit will
automatically set in the standby mode.
NOTES
• If the traffic information broadcast signal falls below a
certain level, the unit remains in the receiving mode for 70
seconds. If the signal remains below a certain level for over
70 seconds, the "T.INFO" indicator blinks.
• If you do not want to listen to the traffic information being
received, lightly press the T.INFO/ANNC. button to skip that
traffic information message. The T.INFO mode will remain in
the ON position to receive the next traffic information
message.
• If the volume level is changed while receiving traffic
information, the changed volume level will be memorized.
When traffic information is received next time, the volume
level will be automatically adjusted to the level memorized.
• In the T.INFO mode, the SEEK tuning selects only the TP stations.
10
-EN
MODE Flipper switch
2/PTY 3/P. PTY

PTY (Programme Type) Tuning

1
Press the F/SETUP button. The "FUNC" indicator will
illuminate.
2
Press the 2/PTY button to activate the PTY mode, in
the FM radio mode. The Programme Type of the station
being currently received will be displayed for 5
seconds.
If there is no receivable PTY broadcast, "NO PTY" will
be displayed for 5 seconds.
NOTE
If no buttons are pressed within 5 seconds after pressing the 2/
PTY button, the PTY mode will be automatically cancelled.
3
Press the and
switch up or down within 5 seconds after activating the
PTY mode to choose the desired programme type
while the PTY (programme type) is being displayed.
Each press scrolls the programme type by one.
Light M Classics
4
Press the 2/PTY button within 5 seconds after
selecting the programme type to start searching for a
station in the selected programme type.
If the received station is found, the programme type of
the received station will be displayed for 5 seconds.
If no station is found, "NO PTY" will be displayed for 2
seconds.
5
Press the F/SETUP button to activate the normal
mode. The "FUNC" indicator will turn off.
NOTES
• Operate the unit while the "FUNC" indicator is illuminated.
If no buttons are pressed within 5 seconds, the "FUNC"
indicator will turn off.
• When the Navigation disc (sold separately) is inserted and the
system is set in navigation mode, the selected language can be
used with the PTY (Programme Type) or P.PTY (Priority
Programme Type) language.
buttons or move the Flipper
Other M