Table of Contents
Advertisement
Navigation System
(Optional)
Switching the Navigation Screen
(Optional)
If an optional Alpine Navigation System is connected to the
IVE-W530EBT/IVE-W530ABT/IVE-W530E , the Navigation screen
can be displayed on this unit.
1
Press SOURCE/
.
The Source Selection screen is displayed.
2
Touch [Nav.].
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner's Manual of the
navigator.
• You can touch [V.Sel] to activate the Visual Sel. screen, and then
touch [Nav.]. The navigation mode is activated from the Visual Sel.
mode without interrupting normal audio. For details, refer to
"Switching the Visual Source Only (Simultaneous Function)" on
page 23.
• You can also directly access to Navigation screen by pressing
[
] on main source screen. For details, refer to "Recalling the
Source" on page 10.
• If the Navigation mode menu is not displayed on the main menu
screen, select ON in "Setting the Navigation Mode" (page 31).
• When the Navigation System is on and in guidance mode, the voice
prompts and navigation map interrupts the current audio source.
Auxiliary Device
(Optional)
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX1, AUX2 or Front AUX
terminals, follow the procedure described below.
WARNING
It is dangerous for the driver to watch the TV/Video
while driving the vehicle. The driver may be distracted
from looking ahead and an accident could occur.
Install the IVE-W530EBT/IVE-W530ABT/IVE-W530E
correctly so that the driver cannot watch TV/Video
unless the vehicle is stopped and the emergency
brake is applied.
If the IVE-W530EBT/IVE-W530ABT/IVE-W530E is not
installed correctly, the driver will be able to watch the
TV/Video while driving the vehicle and may be
distracted from looking ahead and cause an accident.
The driver or other people could be severely injured.
• If you try to activate the auxiliary device while driving, the display
will show the warning-Picture off for your safety.
1
Press SOURCE/
.
The Source Selection screen is displayed.
2
Touch [Aux-1]*, [Aux-2] or [Front AUX].
The external input screen is displayed.
3
Touch [NTSC/PAL] to change the video input.
This step is not applicable to Front AUX mode.
* The name which is given as the source name in "Setting the AUX
Mode" on page 32 is displayed.
• If the AUX mode is not displayed on the main menu, set AUX1 IN to
ON or AUX2 IN to AUX by following "Setting the AUX Mode"
(page 32). Or set AUX Front to ON by following "Setting the AUX
Front Mode" on page 32.
• The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in "Setting the AUX Mode" on
page 32.
• The display mode changes by touching [WIDE].
For operation, refer to "Switching Display Modes" on page 23.
39
-EN
Hide quick links:
Advertisement
Table of Contents
