Installation - Alpine IVE-W530E Owner's Manual

Installation

Caution
Do not block the unit's heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the
unit and may cause a fire.
Heat Sink
Rear of the Unit
Rear of the unit
The main unit must be mounted within 30 degrees of the
horizontal plane, back to front.
Less than 30°
1
Remove the mounting sleeve from the main unit
(Refer to "Removal" on page 51). Slide the mounting
sleeve into the dashboard and fix it with the metal
shackles.
Mounting Sleeve
(Included)
Dashboard
This unit
Face Plate
(Included)
2
Screw
Hex Nut (M5)
2
*
Metal
Mounting
Strap
1
*
Ground Lead
Chassis
Reinforce the head unit with the metal mounting strap
(not supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*
the vehicle's chassis.
2
• For the screw marked "* ", use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from
the left rear of the IVE-W530EBT/IVE-W530ABT/IVE-W530E.
Connect all other leads of the IVE-W530EBT/IVE-W530ABT/
IVE-W530E according to details described in the
CONNECTlONS section.
3
Slide the IVE-W530EBT/IVE-W530ABT/IVE-W530E into
the dashboard until it clicks. This ensures that the unit
is properly locked and will not accidentally come out
from the dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
2. Pull the unit out, keeping it unlocked as you do so.
Bolt Stud
This unit
1
) already attached to
Bracket keys
(Included)
51
-EN